Rubber and plastics hoses for marine-engine wet-exhaust systems - Specification (ISO 13363:2015, IDT)
Status:
Valid
Buy this standard
StandardSwedish standard
·
SS-ISO 13363:2016
Rubber and plastics hoses for marine-engine wet-exhaust systems - Specification (ISO 13363:2015, IDT)
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions
This International Standard specifies requirements for three types and two classes of hose. The hoses are intended for use in marine-engine wet-exhaust systems (where the exhaust gases are mixed with the discharge of cooling water). It does not apply to outboard motor/personal water craft.The three types are the following:— type 1: a softwall hose, made of oil-resistant material, with a synthetic-fabric reinforcement;— type 2: a hardwall hose, made of oil-resistant material, with a synthetic-fabric reinforcement with a helical wire embedded in it;— type 3: a hose or tube (flexible connector), made of oil-resistant material, with or without a reinforcement or cover, intended for use in short lengths in locations where the connector is protected from mechanical damage.The two classes are the following:— class A: intended for diesel engines;— class B: intended for petrol engines and for diesel engines with a very high exhaust temperature.
Rubber and plastics hoses for marine-engine wet-exhaust systems - Specification (ISO 13363:2015, IDT)
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions