StandardSvensk standard
·
SS-EN ISO 2719:2016/A1:2021
Bestämning av flampunkt i sluten degel enligt Pensky-Martens - Tillägg 1: Termometrar korrigering (ISO 2719:2016/DAM 1:2021)
Status:
Gällande
Köp denna standard
StandardSvensk standard
·
SS-EN ISO 2719:2016/A1:2021
Bestämning av flampunkt i sluten degel enligt Pensky-Martens - Tillägg 1: Termometrar korrigering (ISO 2719:2016/DAM 1:2021)
Prenumerera på standarder med tjänst SIS Abonnemang. Genom att prenumerera får du effektiv åtkomst till gällande standarder och säkerställer att ditt företag alltid har tillgång till senaste utgåvan.
Läs mer om SIS Abonnemang
This International Standard describes three procedures, A, B and C, using the Pensky-Martens closed cup tester, for determining the flash point of combustible liquids, liquids with suspended solids, liquids that tend to form a surface film under the test conditions, biodiesel and other liquids in the temperature range of 40 °C to 370 °C.CAUTION — For certain mixtures no flash point, as defined, is observed; instead a significant enlargement of the test flame (not halo effect) and a change in colour of the test flame from blue to yellowish-orange can occur. Continued heating can result in significant burning of vapours outside the test cup, and can be a potential fire hazard.NOTE 1 Although, technically, kerosene with a flash point above 40 °C can be tested using this International Standard, it is standard practice to test kerosene according to ISO 13736.[5] Similarly, lubricating oils are normally tested according to ISO 2592[2].Procedure A is applicable to distillate fuels (diesel, biodiesel blends, heating oil and turbine fuels), new and in-use lubricating oils, paints and varnishes, and other homogeneous liquids not included in the scope of Procedures B or C.Procedure B is applicable to residual fuel oils, cutback residua, used lubricating oils, mixtures of liquids with solids, liquids that tend to form a surface film under test conditions or are of such kinematic viscosity that they are not uniformly heated under the stirring and heating conditions of Procedure A.Procedure C is applicable to fatty acid methyl esters (FAME) as specified in specifications such as EN 14214[11] or ASTM D6751[13].This International Standard is not applicable to water-borne paints and varnishes.NOTE 2 Water-borne paints and varnishes can be tested using ISO 3679[3]. Liquids containing traces of highly volatile materials can be tested using ISO 1523[1] or ISO 3679.
StandardSvensk standard
·
SS-EN ISO 2719:2016/A1:2021
Bestämning av flampunkt i sluten degel enligt Pensky-Martens - Tillägg 1: Termometrar korrigering (ISO 2719:2016/DAM 1:2021)
Prenumerera på standarder med tjänst SIS Abonnemang. Genom att prenumerera får du effektiv åtkomst till gällande standarder och säkerställer att ditt företag alltid har tillgång till senaste utgåvan.
Läs mer om SIS Abonnemang
Internationell titel: Determination of flash point - Pensky-Martens closed cup method - Amendment 1: Thermometers correction (ISO 2719:2016/Amd 1:2021)